Table of Contents
Advertisement
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn over the computer.
4. Remove the base cover assembly. See "Base cover assembly" on page 58.
Type 1
Step 1.
Remove the M.2 solid-state drive as shown below.
Step
Screw (quantity)
1
M2 × 2.5 mm, flat-head, nylon-coated (1)
Step 2.
Install the M.2 solid-state drive in reverse order.
Type 2
Step 1.
Remove the M.2 solid-state drive and its bracket as shown below.
Color
Torque
Black
0.181 Nm
(1.85 kgf-cm)
.
Chapter 8
Removing or replacing a FRU
61
Advertisement
Table of Contents
