Table of Contents
Advertisement
Step
Screw (quantity)
1
M2 × 2.5 mm, flat-head, nylon-coated (1)
Step 2.
Install the M.2 solid-state drive and its bracket in reverse order.
Wireless WAN card and its bracket (for selected models)
Follow the instructions to replace the Wireless WAN card.
The following information is only for the computer with user-installable modules. Ensure that you use only a
Lenovo-authorized wireless module specifically tested for this computer model. Otherwise, the computer will
generate an error-code beep sequence when you turn on the computer.
Before you start, read
Generic Safety and Compliance Notices
Attention: Do not touch the contact edge of the wireless WAN card. Otherwise, the wireless WAN card
might get damaged.
For access, do the following:
1. Disable the built-in battery. See "Disabling the built-in battery" on page 57.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn over the computer.
4. Remove the base cover assembly. See "Base cover assembly" on page 58.
5G models
Step 1.
Remove the wireless WAN card as shown below.
Note: A Mylar film might cover the wireless WAN card. To access the wireless WAN card, peel off
the film first.
62
ThinkPad T14s Gen 5 Hardware Maintenance Manual
Color
Black
and print the following instructions.
Torque
0.181 Nm
(1.85 kgf-cm)
Advertisement
Table of Contents
