Table of Contents
Advertisement
Step 2.
Install the camera module and cable in reverse order.
Note: The LED tape is part of the camera shutter but may stick to the camera module after the
camera module is removed. To avoid light leak, ensure that the LED tape is firmly attached on the
camera shutter.
Wireless LAN antenna assembly
Follow the instructions to replace the wireless LAN and wireless WAN antenna assembly.
For access, remove these FRUs in order:
• "Base cover assembly" on page 58
• "LCD unit" on page 82
• "LCD bezel sheet" on page 84
• "Strip cover" on page 85
• "Hinge cap" on page 86
• "LCD panel, LCD cable and elastic adhesive tapes" on page 87
Step 1.
Remove the wireless LAN antenna assembly as shown below.
Step 2.
Install the Wireless LAN antenna assembly in reverse order.
Attention: When you route the cables, ensure that they are not subject to any tension. Tension
could cause the cables to be damaged by the cable guides, or a wire to be broken.
Antenna locations
The following illustration shows the antenna locations.
.
Chapter 8
Removing or replacing a FRU
91
Advertisement
Table of Contents
