Table of Contents
Advertisement
IFC228-LCD_EN
26/08/04
14:28
AV2
AV1
AV3
Page 23
Sockets
AV1 and AV2 SCART sockets (input-output) at the back
These sockets can be used to connect a range of equipment, including video recorders,
camcorders (VHS, S-VHS, 8 mm or Hi 8), decoders, satellite receivers, DVD players, games
consoles or devices producing an RGB signal.
AV3 SCART socket (input) at the back
This socket can be used to connect equipment, such as video recorders or camcorders
(VHS, S-VHS, 8 mm or Hi 8).
AV3 RCA audio + video sockets (input) on the side
These can be mainly used to connect camcorders (VHS or 8 mm format).
AV3 RCA audio + S sockets (input) on the side
These can be mainly used to connect camcorders (S-VHS or Hi 8 format).
AV4 VGA + RCA audio sockets (input) at the back
These can be used to connect a computer.
AV5 DVI + RCA audio sockets (input) at the back
These sockets can be used to connect a PC with a compatible graphics card, certain DVD
players or a compatible high-definition digital satellite decoder.The DVI socket automatically
detects whether a signal is received when you select the AV5 programme.
Notes:
- To ensure a high display quality, use a cable of less than 5 metres in length and of the quality
required by the DVI standard.
- Do not connect devices supplying analogue RGB signals to this connector.
AV6 CMP + RCA audio sockets (input) at the back
These can be used to connect a DVD player.The component sockets automatically detect
the type of component signal received: interlaced component (YPrPb) or progressive
component (YCrCb).
To display images using the equipment connected, press the
control: once to select AV1, twice to select AV2, etc. For some equipment (connected to
the SCART sockets), this selection is done automatically.
RCA audio + subwoofer sockets (output) on the side
These can be used to connect a stereo amplifier, a hi-fi system or amplified speakers (see
below).
Connecting active speakers
The audio RCA sockets on the side of the television can be used to connect active
speakers (with a built-in amplifier) replacing the television's built-in speakers.
Connect the left speaker to the RCA L socket and the right speaker to the RCA R socket.
Connect the subwoofer to the SUB-WFR socket.
Connecting speakers (on the side)
Connect the left speaker to the L socket and the right speaker to the R socket.
Set the switch to EXT.The TV set's speakers are disabled.
If you disconnect the speakers from the TV set, remember to reset the switch to INT so
EXT
that the TV set's speakers are enabled again.
Other information
23
AV
button on the remote
EN
Hide quick links:
Advertisement
Table of Contents
