Temperature Control; Humidity Control - Igloo LUNA Instruction Manual


Protect the electrical wiring against water.

Do not clean with water jet, use a wet cloth.

Do not use sharp objects to remove dirt!

Do not use mechanical devices to speed up the defrosting!

Lower the night roller blinds (if any) when the store is closed to save electrical energy!

Do not open the door unnecessarily and do not leave the open for a longer time

Do not open the door unnecessarily and do not leave the open for a longer time
When you have closed the door, do not force it open. The negative pressure inside is equalized within 1-2
minutes, allowing easy opening of the door.

Keep the condenser and filter clean. Dirt may cause the compressor overheating, leading to equipment damage
which is not covered by warranty.

Protect the refrigeration circuit against damage! In case of any suspected depressurization of the refrige- ration circuit
and coolant leakage, ventilate the room and call authorized service.
5.3.

Temperature control

The basic aim of a thermostat is to control the cooling aggregate to obtain the set temperature within the device
and maintain it within the determined temperature ranges. The producer enters all settings of temperature
regulators required for normal functioning of the device. Before primary actuation the user should control and
possibly set the required temperature inside the device on the control panel.
Digital display – displays the current temperature inside the device.
It is forbidden to interfere with systemic parameters of the thermostat, as this can lead to serious
consequences, including the damage of the cooling device!
5.4.

Humidity control

NOTE: Applies only to selected refrigerating equipment and can be used only with the IGLOO thermostat.
IGLOO Stary Wiśnicz 289, 32-720 Nowy Wiśnicz, Tel.: +48 14/662 19 10 info@igloo.pl / www.igloo.pl
EN
35