Exploitation; Temperature Regulation - Igloo BASIA M User Manual

4. EXPLOITATION

Temperature of cooled space and operating cycle of the aggregate may vary. They depend on numerous factors,
such as amount and temperature of products placed in the device and the ambient temperature.
The device should be placed in a dry place, not insolated and well ventilated, ensuring proper air circulation (min. 10
cm distance between the wall and the device), far from sources of heat and devices forcing the air circulation (roof
ad mobile ventilators, blowing heaters). The device operates properly in an environment, where temperature falls
within proper climate class stated on the data plate. The operation of the device may worsen, when it will operate in
temperature higher or lower than the one determined in the stated temperature range.
Remarks and indications
• It is essential to properly level the display cabinet, which prevents the loud operation of the device and shall
ensure proper water (condensate) outlet during defrosting.
• After transporting the device, wait about 2 hours before its actuation.
• The first filling of the freezing space should be performed after its previous cooling to working temperature.
This principle should also be observed after longer pause in exploitation.
• Do not place hot products in cooling and freezing devices.
• During the day it is unadvisable to place more products in the chamber of the device than its freezing capacity
can handle.
• It is forbidden to place bottles and cans with drinks in freezing devices. Their content may expand when
frozen, rupturing the container. Risk of injuries and damages!
• Do not block any ventilation holes, which would hamper the cooled air circulation. It is necessary to ensure
proper airflow around the device (aggregate ventilation holes cannot be covered!!!!).
• Keep the condenser clean. Impurities may lead to overheating of the compressor and as a consequence may
result in damage of the device, which is not covered by warranty.
• Do not use electric devices inside grocery product storing chamber

4.1. Temperature regulation

"Igloo" and "Carel" thermostat (temperature regulators) service is described in chapter 7 (p. 19 and 20)
The basic aim of a thermostat is to control the cooling aggregate to obtain the set temperature within the device and
maintain it within the determined temperature ranges. The producer enters all settings of temperature regulators required
for normal functioning of the device. Before primary actuation the user should control and possibly set the required tem-
perature inside the device on the control panel.
Digital display – displays the current temperature inside the device.
It is forbidden to interfere with systemic parameters of the thermostat, as this can lead to serious consequ-
ences, including the damage of the cooling device!
www.igloo.pl User manual BASIA M
en
15