Exploitation; Temperature Regulation; Fig.4 Control Panel - Igloo JAMAJKA Series User Manual

Heated display cabinet

Table of Contents

Available languages

4. EXPLOITATION

Temperature of the heated exhibition space may vary. It depends on numerous factors, such as amount and tempe-

rature of products placed in the device and temperature of the surroundings. The device should be placed in a dry

and well-ventilated place.

Remarks and indications

• Before placing hot products in the display cabinet, an empty display cabinet should operate until the

desired working temperature shall be obtained

• Do not place cold products in the device

• Do not block ventilation holes, as it could hamper the hot air circulation inside the device Fig.8/1; 3 (p.13)

• Goods stored on the shelves of the display cabinets need to be placed in a manner ensuring even load

of the shelves and free ﬂ ow of hot air.

Heated device is equipped with mechanical temperature regulator. Set the desired water temperature inside the

device Fig.4/5 (p.11) with the help of regulating knob by turning it and setting in proper position. Turning the knob

clockwise increases the set temperature, and turning it in the opposite direction causes its decrease. Turning the

knob left, until it reaches the ﬁ nal position turns off the heaters, despite the fact that the power supply is activated.

www.igloo.pl

3 – Red control diode – lack of water or low water level (this is not an alarm signal!)

1 – Main switch – for electric heater

2 – Lighting switch – for bulbs inside the device

4 – Green control diode – proper water level

5 – Temperature regulator knob

User manual Jamajka G

Table of Contents

Table of Contents