Electronic Temperature Regulator (Thermostat); Igloo" Thermostat - Igloo LUNA Instruction Manual

8.

ELECTRONIC TEMPERATURE REGULATOR (THERMOSTAT)

8.1.

„IGLOO" thermostat

1 2
7 6
Fig. 7 "IGLOO" thermostat panel
Check the set temperature (inside the equipment) – Press"
set tempera- ture appears on the display, accompanied by a blinking red dot (LED). The preview will end
automatically after about 3 seconds.
Increase or decrease the temperature - press „
Press „ " to reduce the temperature to the desired value. The function will be deactivated automatically after
about 3 seconds.
Manual defrosting – press button 2 to start the defrosting cycle anytime (independently of the automatic
defrosting func- tion); the button is inactive when the temperature is higher than the defrosting end temperature.
•It is recommended to turn the unit on/off using only the man switch, and not the switch „
thermostat panel. Putting the main switch to ON automatically starts the thermostat!
IMPORTANT: If the main switch is ON and the display shows only two dots, it means that the thermostat
is off and should be activated. Press the button „
* More on www.igloo.pl
IGLOO Stary Wiśnicz 289, 32-720 Nowy Wiśnicz, Tel.: +48 14/662 19 10
3 4
5
" (or „ ") and the panel will display the set temperature.
" on the thermostat panel.
1 – Refrigeration on/off button
2 – Manual defrosting button
4 – Increase temperature button
5 – Decrease temperature button
6 – Temp. preview buton on the defrost
sensor. The button is used to change
the internal parameters of the
7 – Mini USB temperaturę recorder
" or „ " once to check the temperature. The
info@igloo.pl / www.igloo.pl
EN
3 – Digital display
controller.
" on the
41