Table of Contents
Advertisement
In order to achieve a correct vacuum action, clean the filter every 10 minutes and always before any
discharge of the debris hopper.
To do this, proceed as follows:
1.
Lift the central brush by turning the left lever (2) clockwise.
2.
Lift the side brush if lowered, by rotating the right lever (4) clockwise.
3.
Activate the filter shaker by pressing the button (7) on the control handlebar, the vacuum
automatically terminates.
Periodically check the filling of the tray and if necessary proceed to empty it. Keep in mind that the weight
of the waste collected is proportional to the specific weight of the material swept. In the case of heavy
material such as sand, earth, gravel, etc. the tray should ideally not be filled more than 70%, otherwise it
may be difficult to empty.
The Hybrid machine in combustion engine mode must be used in outdoor or highly ventilated
environments. The combustion engine mode guarantees the recharging of the batteries supplied with the
machine, allowing to increase the duration of the work, but there is not a device that warns that the
batteries are fully recharged.
WARNING: The transition from battery to hybrid must be performed at a standstill.
31. EMERGENCY BUTTON
If there are any problems while you are working, press the emergency button (1) beneath the seat (B
versions) or on the steering column (H VERSIONS). This command interrupts the electric circuit between
the batteries and the machine system, so the machine stops and the electric brake is triggered.
To resume work, having solved the problem, proceed as follows:
1.
Rotate the key (2) of the main switch to the "0" position.
2.
Move button (1) to the standard position
3.
Turn the key (2) of the main switch to "I" or "II", depending on the type of power source you want to
use.
WARNING: The images refer to the Hybrid version.
32. ALTERNATOR FAULT WARNING LIGHT (H VERSIONS)
If there are problems with the operation of the alternator when working with combustion engine mode (H
VERSIONS), the red warning light (1) on the steering column lights.Move the machine to the maintenance
area and contact the specialised assistance centre.
WARNING: As soon as the red warning light (1) is activated, stop the machine and
contact the assistance centre.
WORK
31
31
Advertisement
Table of Contents
