How To Assemble Your Light Kit - Fanimation BRAWN FPD6605 Series Manual

CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
1.
Remove one of the four screws in the support
bracket at the bottom of the motor assembly. Retain
the screw for later and slightly loosen the remaining
three screws. (Figure 1)
2. Assemble the light housing assembly to the support
bracket using the three key slots in the light housing
assembly. Replace the previously removed screw and
securely tighten all four screws. (Figure 2)
3. Remove one of the three screws in the light housing
assembly. Retain the screw for later and slightly
loosen the remaining two screws. (Figure 3)
4. Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from the
motor assembly. (Figure 4)

How to Assemble Your Light Kit

Motor Assembly
Light Housing
Assembly
Light Housing
Assembly
Motor Assembly
LED Assembly
13
Figure 1
Figure 2
Figure 3
Figure 4