How To Assemble Your Light Kit - Fanimation EIGHTYFOUR LP6827 Series Instructions Manual

How to Assemble Your Ceiling Fan Blades (Continued)
2. Secure the blade cover to the hub of motor
assembly using 3/16˝-24 flat head screw. (Figure 2)
HARDWARE USED:
3/16"-24
Flat Head Screw
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly. Retain
the screw for later and slightly loosen the remaining
two screws. (Figure 1)
2. Assemble the switch housing assembly to the
support bracket using the two key slots in the switch
housing assembly. Replace the previously removed
screw and securely tighten all three screws.
(Figure 2)
3. Remove one of the three screws in the switch
housing assembly. Retain the screw for later and
slightly loosen the remaining two screws. (Figure 3)
x 18

How to Assemble Your Light Kit

3/16˝-24
Flat Head Screw
(2 each per
blade cover)
Blade Cover
Motor
Assembly
Switch Housing
Assembly
Switch Housing
Assembly
13
Motor Assembly
Figure 2
Figure 1
Figure 2
Figure 3