How To Assemble Your Light Kit Assembly Or Cap - Fanimation BLITZ LP8377 Series Manual

How to Assemble Your Light Kit Assembly or Cap

1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly. Retain
the screw for later and slightly loosen the remaining
two screws. (Figure 1)
2. Assemble the light kit to the support bracket using
the two key slots in the light kit. Replace the
previously removed screw and securely tighten all
three screws. (Figure 2)
3. Remove one of the three screws in the light kit.
Retain the screw for later and slightly loosen the
remaining two screws. (Figure 3)
4. If installing the light kit, skip this step.
Assemble the light kit wire cover to the light kit using
the two key slots. Replace the removed screw and
secure all three screws. (Figure 4)
5A. For use with light kit.
Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from motor
assembly. (Figure 5A)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
5B. For use with steel cap.
If you want to install the steel cap and not the light kit.
Assemble the steel cap to the light kit by twisting in a
clockwise direction. (Figure 5B)
NOTE: If you have installed your fan with the steel
cap, skip Steps 6 and 7.
Motor
Assembly
Motor
Assembly
Light Kit
Light Kit
Wire Cover
Figure 5A
13
Figure 1
Figure 2
Figure 3
Figure 4
Light Kit
LED
Assembly
Figure 5B
Light Kit
Light Kit
Steel Cap