How To Assemble Your Light Kit Assembly Or Cap - Fanimation TORCH FP8458 Series Manual

How to Assemble Your Light Kit Assembly or Cap

1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly. Retain
the screw for later and slightly loosen the remaining
two screws. (Figure 1)
2. Assemble the light kit to the support bracket using
the two key slots in the light kit. Replace the previously
removed screw and securely tighten all three screws.
(Figure 2)
3. Remove the three screws in the light kit and
retain the screws for later. (Figure 3)
5A. For use with light kit.
Connect the 2 single pin connector from the LED
assembly to the 2 single pin connector from motor
assembly. (Figure 5A)
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
NOTE: If you have installed your fan with the steel cap,
skip Steps 6 and 7.
Motor
Assembly
Light Kit
Light Kit
Light Kit
Light Kit
Wire Cover
LED Assembly
Figure 5A
12
Figure 1
Figure 2
Figure 3
Figure 4
Light Kit
Steel Cap
Figure 5B