How To Operate Your Ceiling Fan - Fanimation BRAWN FPD6605 Series Manual

How to Assemble Your Light Kit (Continued)
5. Assemble the LED assembly to the light housing
assembly using the two key slots. Replace the
previously removed screw and securely tighten all
three screws. (Figure 5)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
6. Secure the glass to LED assembly by twisting in a
clockwise direction. Twist the glass gradually
snaps onto the LED assembly.
Do not over-tighten. (Figure 6)
1.
IMPORTANT: Using a full range dimmer switch (not
included) to control fan speed will damage the fan. To
reduce the risk of fire or electrical shock, do not use a
full range dimmer switch to control the fan speed.
(Figure 1)
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades are in place. Noise and fan damage
could result.
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.

How to Operate Your Ceiling Fan

Light Housing
Assembly
until it
LED
Assembly
Glass
14
Figure 5
Figure 6
For illustrative purposes only-not
intended to cover all types of controls
Figure 1
Figure 2
LED
Assembly
Main Fuse Box