How To Assemble Your Light Kit Or Cap - Fanimation KLEAR FPD6858 Series Manual

How to Assemble Your Light Kit or Cap

CAUTION
To Reduce The Risk Of Electric Shock, Disconnect
The Electrical Supply Circuit To The Fan Before
Installing Light Kit.
1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly and
retain the screw for later. Slightly loosen the
remaining two screws. (Figure 1)
2. Assemble the switch housing assembly to the
support bracket using the two key slots in the
switch housing assembly. Replace the previously
removed screw and securely tighten all three screws.
(Figure 2)
3. Remove the three screws in the switch housing
assembly and retain the screws for later. (Figure 3)
Motor
Assembly
Switch Housing
Assembly
Switch Housing
Assembly
Switch Housing
Assembly
Light Kit Wire Cover
14
Figure 1
Figure 2
Figure 3 Figure 3
Figure 4