Wireless Wan Card (For Selected Models) - Lenovo ThinkPad L13 2-in-1 Gen 5 Hardware Maintenance Manual

Wireless WAN card (for selected models)

Follow the instructions to replace the wireless WAN card.
The following information is only for the computer with user-installable modules. Ensure that you use only a
Lenovo-authorized wireless module specifically tested for this computer model. Otherwise, the computer will
generate an error-code beep sequence when you turn on the computer.
Before you start, read
Generic Safety and Compliance Notices
Attention: Do not touch the contact edge of the wireless WAN card. Otherwise, the wireless WAN card
might get damaged.
For access, do the following:
1. Turn off the computer and disconnect the computer from ac power and all connected cables.
2. Close the computer display and turn over the computer.
3. Remove the ThinkPad Pen Pro. See "ThinkPad Pen Pro (for ThinkPad L13 2-in-1 Gen 5 only)" on page
62.
4. Remove the base cover assembly. See "Base cover assembly" on page 63.
Step 1.
Note: A Mylar film might cover the wireless WAN card. To access the wireless WAN card, peel off
the film first.
Remove the wireless WAN card as shown below.
Step Screw (quantity)
1
M2 × 2 mm, flat-head, nylon-coated (1)
Step 2. Install the wireless WAN card as shown below.
70
ThinkPad L13 Gen 5,ThinkPad L13 2-in-1 Gen 5 and ThinkPad S2 Gen 9 Hardware Maintenance Manual
and print the following instructions.
Color
Silver
Torque
0.181 Nm
(1.85 kgf-cm)