Base Cover Assembly - Lenovo ThinkPad L13 2-in-1 Gen 5 Hardware Maintenance Manual

Step 2. Install the ThinkPad Pen Pro in reverse order.

Base cover assembly

Follow the instructions to replace the base cover assembly.
Before you start, read
Generic Safety and Compliance Notices
Note: Do not remove the base cover assembly when your computer is connected to ac power. Otherwise,
there might be a risk of short circuits.
For access, do the following:
1. Turn off the computer and disconnect the computer from ac power and all connected cables.
2. Close the computer display and turn over the computer.
3. Remove the ThinkPad Pen Pro. See "ThinkPad Pen Pro (for ThinkPad L13 2-in-1 Gen 5 only)" on page
62
Step 1. Remove the base cover assembly as shown below.
and print the following instructions.
.
Chapter 8 Removing or replacing a FRU
63