• "LCD unit" on page 91
• "LCD bezel" on page 94
• "LCD panel" on page 93
Step 1.
Remove the camera-and-microphone cable and sensor board cable as shown below.
Step 2.
Install the camera-and-microphone cable and sensor board cable in reverse order.
Microphone rubber and camera-and-microphone module
Follow the instructions to replace the microphone rubber and camera-and-microphone module.
For access, remove these FRUs in order:
• "Base cover assembly" on page 63
• "LCD unit" on page 91
• "LCD bezel" on page 94
• "LCD panel" on page 93
Step 1.
Remove the microphone rubber and camera-and-microphone module as shown below.
.
Chapter 8
Removing or replacing a FRU
97