Introduction; Listing And Code Approvals; Appliance Certification; Btu & Efficiency Specifications - J. A. Roby STRATO Instruction Manual

Hide thumbs Also See for STRATO:
Table of Contents

Advertisement

Introduction

Read all instructions carefully before installing your new J. A.
ROBY wood cookstove. A proper installation is very important
for a safe and effective use of your stove. If you have any
doubts about the installation of your appliance correctly, we
suggest to call a professional installer. A wrong installation may
result in a fire, injury or loss of life.
Keep these instructions for future use.
This appliance must be connected to
A type factory-built chimney approved ULC S629 with
6 inches diameter (15.24 cm);
A conforming masonry chimney of 6 inches diameter
(15.24cm) with qualified internal lining
N.B: Please be aware that the local codes and regulations
might be more specific than this manual. You can consult a
professional installer, the Fire Department or local authorities
about restriction on installation of solid-fuel burning appliances.

Listing and code approvals

Appliance certification

The appliance meets the CSA B415.1 cord wood emission
standard.
This appliance also meet:
ULC S627-2021 Standard for Space Heaters for Use
with Solid Fuels.
BTU & Efficiency Specifications
LHV efficiency : 79.46%
HHV efficiency : 73.85%
Particle emission : 1.02 g/h
Particle emission : 0.043 g/MJ
Minimum burn rate 0.99 Kg/hr
Minimum Heat Output* : 14 460 BTU/hr
Maximum Heat Output* : 51 865 BTU/hr
Vent size 6"
Firebox size 1.99 cubic feet
Recommended wood length: 15 inches
Chamber combustion depth: 20 inches
Fuel Orientation: front to rear.
Fuel: Seasoned cord wood.
* A range of BTU outputs based CSA B415.1 Default Efficiency
and the burn rates from the low and high CSA B415.1 emission
tests, using cord wood.

Efficiency

The average of the efficiency of the stove is 76.6%. When the
seasoned wood has lower moisture, the efficiency will be
better. When the outside temperature is really cold, it is
important to create a good draft in chimney. When the
appliance is in the basement, the chimney is higher than if the
appliance would be in the main living area. The draft will be
better because we have more length of chimney.
PR_I029/2023-08-24-EN

Warning

-DO NOT USE CHEMICALS OR FLUIDS TO START THE
FIRE
-DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS
If this appliance is in an area where children may be near,
it is recommended that you place a decorative barrier in
front of the appliance.
HOT WHILE IN OPERATION. KEEP CHILDREN,
CLOTHINGS AND FURNITURES AWAY. CONTACT MAY
CAUSE SKIN BURNS
N.B: BE WARNED THAT THE LOCAL CODES AND RULES
CAN HAVE MORE SPECIFIC REQUIREMENT THAN THIS
MANUAL. YOU CAN CONSULT A PROFESSIONAL
INSTALLER, OR ASK FIRE OFFICIALS OR LOCAL
AUTHORITY ABOUT RESTRICTION AND INSTALLATION
INSPECTION IN YOUR AREA.
YOU MIGHT NEED TO OBTAIN A PERMIT FOR
INSTALLING CHIMNEY AND STOVE.
DO NOT CONNECT THIS APPLIANCE TO A CHIMNEY
FLUE SERVING ANOTHER APPLIANCE.
DO NOT CONNECT TO OR USE IN CONJUNCTION WITH
ANY AIR DISTRIBUTION DUCTWORK UNLESS
SPECIFICALLY APPROVED FOR SUCH INSTALLATIONS.
THIS APPLIANCE IS BUILT FOR BURNING SEASONED
CORDWOOD ONLY. USE OF ANY OTHER TYPE OF FUEL
LIKE COAL/ CONSTRUCTION WOOD/ TREATED WOOD/
FLAMABLE LIQUID/ TRASH/ OR ANY FLAMABLE THING
CAN OVERFIRE AND DAMAGE THE STOVE.
THE ROOM HEATER SHALL NOT BE INSTALLED IN A
FACTORY-BUILT FIREPLACE.
DO NOT INSTALL IN AN ALCOVE
DO NOT CONNECT THIS APPLIANCE TO A
CHIMNEY
APPLIANCE.
Revision: 7
FLUE
SERVING
ANOTHER
3

Advertisement

Table of Contents
loading

Table of Contents