Table of Contents
Advertisement
Chimney connector installation
The chimney connector is a set of single wall flue pipes and
elbow installed between the stove collar and the chimney collar.
Components of single wall chimney connector are available at
any hardware store and there is no precise standard or
regulation. However, some rules must be followed to install solid
fuel burning equipment.
Your J.A. Roby cookstove was approved for the use of a
single wall chimney connector.
❖
Single wall chimney connector
For the single wall chimney connector, you must use the
connector of 6 inches diameter with a minimum thickness
of 24 gauge (0.025 inches 0.64 mm).
ATTENTION:
•
Any horizontal section must be sloping upwards
1/4 inches (6.35 mm) by feet (30 cm) toward the
chimney collar. This section should not exceed
36 inches (91.4 cm).
•
The clearance between the roof and the single wall
chimney connector must be 18 inches (45.7 cm) or
more.
1.
Assembly of connecting parts
Make a brief installation of all sections and elbows (if necessary)
to ensure that you respect the clearances and inclinations of the
horizontal sections. You must also verify if you have all the
necessary parts for final installation.
o For direct vertical installation, you will need:
▪ 1 x vertical section of 24 inches (61 cm) or more
▪ 1 x adequate length of telescopic chimney part allowing
you to connect the last chimney connector section to
the chimney collar.
Note: For higher roof, more parts might be needed.
o For horizontal installation, you will need:
▪ 1 x vertical section of 24 inches (61 cm) or more;
▪ 1 x 90° elbow;
▪ 1 x adequate length of telescopic chimney part.
Note: For better performance, two 45 degree elbows
with or without straight section in between are
preferable.
2.
Disassemble the whole thing and start screwing the pieces
from the stove to the roof chimney collar.
PR_I029/2023-08-24-EN
3.
Insert entirely the roll formed end into the stove collar and
screwing it with a minimum of 3 screws.
WARNING: It is mandatory to attach the pipe to the
stove collar and also at each joint with at least of 3
screws.
4.
Install all the next section up to the chimney support collar
and be sure to attach all parts with at least 3 screws.
ATTENTION: It is OBLIGATORY to attach the pipe on
the stove flue collar and each joint with at least 3
screws.
5.
Install all other parts and attach them up to the chimney
collar.
6.
Attach the connection pipe with 3 screws.
DO NOT CONNECT THIS APPLIANCE TO A CHIMNEY
SERVING ANOTHER APPLIANCE.
CONNECTOR PIPES SHOULD NEVER GO ACROSS A
CEILING, A WALL, A CLOSET, AN ATTIC OR OTHER
ENCLOSED AREA THAT
BUILDUP.
IF
COMBUSTIBLE MATERIAL, MAKE SURE THAT YOUR
INSTALLATION COMPLIES WITH CAN / CSA-B365.
Installation in a mobile home
DO NOT INSTALL THIS APPLIANCE IN A
MOBILE HOME.
Revision: 7
COULD CAUSE HEAT
YOU
NEED TO
PASS THROUGH
19
Advertisement
Table of Contents
