Troubleshooting - Reolink RLC-540A Quick Start Manual

4
0°
1
2
3
5
6
9 English
Adjust the camera's viewing
angle as needed.
Align the arrows and the notch
according to the diagram.
1. Arrows on camera base
2. Notch on camera module
3. Arrow on camera top
Attach the dome cover to the
camera base by tightening the
screws.
NOTE: Remove the protective film
from the dome cover after the
installation.

Troubleshooting

Camera is not Powering on
If your camera is not powering on, please try the following solutions:
• Make sure your camera is powered on properly. The PoE camera should
be powered by a PoE switch/injector, a Reolink NVR or a 12V power
adapter.
• If the camera is connected to a PoE device as listed above, connect it to
another PoE port and check again.
• Try again with another Ethernet cable.
Picture is not Clear
If the picture from the camera is not clear, please try the following
solutions:
• Check the camera dome cover for dirt, dust or spiderwebs, and clean
the dome cover with a soft, clean cloth. The dust-absorber included in the
package is recommended.
• Point the camera to a well-lit area, the lighting condition will affect the
picture quality a lot.
• Upgrade the firmware of your camera to the latest version.
• Restore the camera to factory settings and check out again.
English 10