Use Of Buttons - Sym XH12WW-EU Series Owner's Manual

§USE OF BUTTONS §
High/low beam
switch
Turn Signal Switch
 Electrical starter button
this is a starting motor button(switch) for engine starting.
With the main switch "on", press this button while holding the front or rear brake lever will
start the engine.
CAUTION:
 Release this button immediately after engine has been starter, and never press the button
again to avoid damaging the engine.
 This mechanism is a safety design. The engine can only be started after the front or rear brake
lever (pedal) has been applied.
 Do not use light system. Turn headlight and turn signal light to the "off" position when the
engine is being started.
 High/low beam switch
This is the high and low beam of headlight switching switch. Press this switch to switch between
high and beams.
This is for high beam.
This is for low beam.(please turn to low beam riding in city.).

 Hazard warning switch

When the switch is turned to this position as the engine is being started, the front and rear
turn signal lights will flash.
 Engine Stop Switch
Switch to this position to turn off the engine when a state of emergency.
Switch to this position and the engine can be started.
 Passing switch
Turn ignition switch to the"ON" position and press this button down. Then, the high
Passing
beam of headlight will come on immediately to warn the driver of the vehicle ahead that
you intend to overtake him/her.(For overtake, high beam indicator will come on at this
time ) This button will return to original position after releasing
Passing
Horn Switch
11
Hazard warning
switch
Engine Stop Switch
Position switch
Mode:XH15WX-
VNC/XH15WW-VNC
Electrical starter
button