Throttle Valve Handle Clearance Adjustment; Inspection And Maintenance Of Battery - Sym XH12WW-EU Series Owner's Manual

(Replenishment of front wheel brake fluid)
1.Loosen the screws and remove the master cylinder cover.
2.Wipe clean foreign materials, dirt around the reservoir, being
careful not to let foreign materials fall into the reservoir.
3. Remove the diaphragm plate and the diaphragm.
4. Add brake fluid to upper lever.
5.Install the diaphragm plate and the diaphragm, and install the
master cylinder cover.
6.please note the diaphragm direction, and do not let foreign
materials fall into the reservoir. And tighten the master
cylinder cover securely.
CAUTION:
 To prevent chemical reaction, please do not use brake fluids other than those recommended.
 Do not fill above the upper limit when adding brake fluid and avoid dropping on painting or
plastic components to prevent damage.
§THROTTLE VALVE HANDLE CLEARANCE ADJUSTMENT §

Correct clearance allows throttle vale handle to rotate
2~6mm.

Loosen the lock nut first, then turn the adjust nut to
adjust. Tighten the lock nut securely when finished.
Check Items:
1. Check throttle valve cable to see if it can be
moved smoothly from a closed position to a wide
open position.
2. Rotate steering handle from side to side to check
if the throttle valve cable is interfered.
3. Check to see if the throttle valve cable is
obstructed by other cables preventing it from
being operated smoothly.
§INSPECTION AND MAINTENANCE OF BATTERY §
 The scooter is equipped with a maintenance-free type battery, so it is unnecessary to check and add
electrolyte. Have your scooter checked by SYM Authorized Dealer or Franchised Dealer should any
abnormality is found.
(Cleaning of battery terminals)
 Remove the battery terminals and clean if there are
dirt and corrosion on them.
 Battery removal procedures are as follows:
Turn ignition switch to the "OFF" position, then
remove negative cable screw firstly and disconnect
the negative cable. Then, remove positive cable
screw and positive cable.
Master cylinder
cover
Diaphragm
Adjust nut
Negative
Positive
19
Screw
Upper
2~6 mm
Lock nut
Brake fluid