Use Of Each Component; Gauges - Sym XH12WW-EU Series Owner's Manual

7. USE OF EACH COMPONENT

(The following is SYM 4 stroke air-cooling125c.c./200c.c.scooter's basic operation, and
they could vary from different individual models. Please consult the end of this manual.)
§GAUGES §
The panel figure for speedometer may vary from model to model, but the location usually are the
same.
Tachometer
"M" button
Fuel meter
Turn Left Signal
Indicator
High Beam
Indicator
CAUTION:
Do not wipe plastic components, e.g. instrument panel, headlight, with organic solvents such as
gasoline...etc to avoid damaging these components.
 Speedometer/ Tachometer：
Indicates driving speed or engine rpm.
 Odometer:
Indicates total accumulated distance traveled.
 Trip Kilometer:
The rider can measure the trip kilometers.
In normal display status, press "MODE" button for 1second,it can show total distance traveled.
Press "MODE" button again, then it can switching over trip kilometer display mode.
In trip kilometer display status, press "SET" button for a long time, it can eliminate the mileage value.
 High Beam Indicator：
This indicator comes on with high beam headlight is turned on.
 Turn (left/right) Signal Indicator：
The left or right Indicator will be flashing according to the operated directions of turn signal light switch
when it is turned on.
 Fuel Meter:
The pointer in this meter shows how much fuel remains in the tank.
The pointer stays in "E" position when key switch is turned to "OFF".
 Cooling temperature indicator(For:XH12WW-EU,XH12WX-EU,XH15WW-VNC,XH15WX-VNC):
Indicates the engine cooling water temperature, engine cooling water temperature indicator if light,
should check the cooling water is sufficient and the fan motor is running.
 Voltmeter/time:
Display average voltage of battery or time.
Cooling temperature
Indicator
ABS Indicator
Fault indicator light
Speedometer
6
Voltmeter/time
"S" button
Trip Kilometer/
Odometer
Turn Right Signal
Indicator
Position Indicator
Engine oil replacement
warning Indicator