Jet Menu; Clean Cycle; Memory - HotSpring HIGHLIFE GRANDEE Owner's Manual

JET MENU

Press on Home screen to display Jet Menu screen.
Depending on you spa model you will see one of the following screens.
Jets
Jets
JET 2
JET 1
Press this icon to turn on the high speed Jet
pump.
Press this icon to turn on the low speed Jet
pump.
Press this icon to turn all jet pumps off (if on) or
turn both jet pumps on high speed (if off).
Press this icon to turn off the low speed Jet
pump.
Press this icon to turn off the high speed Jet
pump.

CLEAN CYCLE

Press on Home screen to display Clean Cycle screen.
The Clean Cycle mode will start up jet pump(s) and run them for a
predetermined amount of time.Clean Cycle is used mostly when adding
chemicals or flushing out the jets plumbing lines.
The Clean Cycle screen allows you to select an instant clean cycle time
of 10 minutes, or start the Auto Clean Cycle mode.
Clean Cycle
Press this icon to activate jet pump 1 on high speed
for a ten minute period.
Press this icon to display the Auto Clean Cycle
Screen.
Home Screen
Jets
Jets
JET
Page 18
HOUR MINUTE
AM
In the Auto Clean Cycle Screen you will be able to set the time of day you
would like the clean cycle to run every day.
NOTE: The clean cycle time CAN NOT overlap with the Energy Savings
Mode.
• Use the + or - buttons under Hour and Minute to set the exact time
of day you would like the clean cycle to go on.
• Set for AM or PM (the AM/PM button will ONLY display when clock
is set to 12 hour mode.
• Press the button to Activate the Auto Clean cycle to run at the
time of day you set. Press
When activated, a clean cycle will run Jet 2 for 1 minute and Jet 1 for 9
minutes (10 minutes for spas with only Jet 1). Status Indicator
show up on screen top bar when in Auto Cycle mode and "Clean Cycle
On" will show up when the cycle is ON.

MEMORY

The Memory Screen will allow you to take one or two of your favorite
combinations of jets and lights and save them to be used at any time.
Press on Home screen to display Memory screen.
Memory
SET
SET
Once you find your favorite combination of jets and
lights press this button next to Memory 1 to enter the
combination into Memory 1. Repeat next to Memory 2 if a
second combination is desired.
Whenever you want to activate Memory 1 simply press
this button.
Whenever you want to activate Memory 2 simply press
this button.
Auto Clean Cycle Screen
to deactivate Auto Clean cycle.
Home Screen
Operating Instructions
will