5. Loosen the six screws securing the connector panel.
Move the connector panel in the arrow direction 1,
and open it in the arrow direction 2.
Connector panel assembly
n
Do not open/close the connector panel with the cable
connected. If the connector panel opens/closes with the
cable connected, the opening/closing mechanism may be
deformed.
SRW-1
Screws with stopper
B3 x 12
2
1
Screws with stopper
B3 x 12
1-8. Removing/Installing Cassette
Compartment Assembly
n
Power off the unit, and then remove/install the cassette
compartment assembly in the following procedure.
n
The cassette compartment assembly can be removed
irrespective of its position (up state or down state).
Removal
1. Remove the outside lid assembly.
(Refer to Section 1-6-1.)
2. Remove the outside panel assembly.
(Refer to Section 1-6-1.)
3. Remove the cable holder 2.
4. Disconnect the flexible card wire (FL-260 board) from
the connector CN1 on the CCM-52 board.
n
Life of flexible card wire (FL-260 board) will be
significantly shortened if it is folded.
Be very careful not to fold the flexible card wire.
CCM-52 board
CN1
FL-260 board
Cable holder 2
1-7 (E)