Table of Contents
Advertisement
5.2
Functions
5.2.1
Hold function
The currently displayed measured value can be frozen on the display by pressing the HOLD key.
"HOLD" also appears on the display.
Press the HOLD key again to unlock the display.
5.2.2
Zero function
If the device displays incomprehensible values, you can use the zero function. To do this, place
the protective cap on the sensor and press the zero key. If the protective sensor cap is not fitted,
the display will show "CAP". If the sensor protection cap is fitted, the device sets the displayed
illuminance to 0.
5.2.3
MAX/AVG/MIN function
The device can show the maximum, minimum or average value on the display. To do this, press
the ▲ key. The display now shows "MAX" as well as the maximum value since the function was
activated. You can now use the ▲ key to switch between the maximum ("MAX"), minimum ("MIN")
and average value ("AVG") display.
Press and hold the ▲ key to exit the function.
5.2.4
Change unit of measurement
Press the LX/FC/CD key to switch between the units "LX" (lux) and "FC" (foot-candles).
5.2.5
Memory
MEM (memory)
Press the MEM/READ key to save the current measured value. When saving, "M" and the
memory location number ("NO. 01" ... "NO.99") appear briefly in the top left of the display.
Read (read memory)
Press and hold the MEM/READ key until an "R" symbol and the memory location display "NO.
XX" appears. You can now navigate between the individual memory locations using the ▲ and
▼ keys. The measured values of the individual memory locations are shown in the measured
value display.
To return to measuring mode, press and hold the MEM/READ key.
Clear (delete memory)
When the measuring device is switched off, press the MEM/READ and the On/off keys
simultaneously. The display now shows "CLR" and all saved measured values are deleted.
© PCE Instruments
5
Advertisement
Table of Contents
