Regeneration Frequency Setup (Models With Softener) - Smeg CWG400B Manual

6.7 Regeneration frequency setup (models with softener)

6.7.1 Table of parameters
ID Washing cycles between regenerations
H0 Function off (value set when dishwasher is supplied)
H1 94 washing cycles
H2 83 washing cycles
H3 53 washing cycles
H4 33 washing cycles
H5 27 washing cycles
H6 20 washing cycles
Hardness (°dH German degrees)
Regeneration off
8,5
11
17
22,5
28
33,5
Regeneration cycle duration: 12 minutes
6.7.2 Memorisation procedure
To access the programming menu, proceed as follows:
1) switch the appliance off by pressing the OnOff key
2) Hold down the
3) Use the key to modify the parameter; H0,H1,H2,H3,H4,H5 and H0 will appear on the display in cyclic
sequence
4) Press the OnOff key to confirm the change and quit programming mode.
With values over 60°dF an external water treatment device must be used and the regeneration frequency
must be set on H00.
Hardness (°dF French degrees)
Regeneration off
keys simultaneously for 6 seconds; H0 appears on the display
and
15
20
30
40
50
60
12
Setting level
H00
H01
H02
H03
H04
H05
H06