Autostart Function; Regeneration Frequency Setup (Models With Softener); Tstp (Minimum Rinsing Temperature) Function - Smeg CWG420D Manual

6.7 Autostart function
Set at "on" to start the cycle when the door is closed.
Set at "off" for cycle start after confirmation with the start button
6.8 Regeneration frequency setup (models with softener)
 (Default value: H03; modify the parameter to suit the mains water hardness.
 At first use, the salt tank has to be filled. It is subsequently sufficient simply to fill up with
regenerating salt when necessary.

Regeneration cycle duration: 12 minutes
With values over 60°dF an external water treatment device must be used and the regeneration
frequency must be set on H00.
6.9 tStP (minimum rinsing temperature) function
Set at "on" for minimum rinsing temperature as set; set at "off" for rinsing regardless of boiler
temperature.
If the parameter is set as "off" and hot intake water is not used, the minimum rinsing temperature
might be a few degrees lower than the setting.
‐ CW 420/430
Modify the parameter (ON/OFF) by pressing
Hardness
(°d German
Modify the degrees)
value of the
Regeneratio
parameter by
pressing .
Modify the parameter (ON/OFF) by pressing
19
Hardness (°f
French
degrees)
Regeneration
n off off
8.5 15
11 20
17 30
22.5 40
28 50
33.5 60
.
Setting
level
H00
H01
H02
H03
H04
H05
H06
.