First Use Each Day (Tank And Boiler Empty) - Smeg CWG400B Manual

8.3 FIRST USE EACH DAY (tank and boiler empty)

Display shows
R
P
WARNING! If the appliance is connected to cold water, wait at least 15' before moving on to the next
phase to give the tank time to reach the correct washing temperature.
R
R
When the door is closed again, the system offers the last program run.
52
Actions and what happens
Door closed and master switch on ON:
Press and hold down for 2-3 seconds; the L1 ON/OFF
light and the two digits on the display light up.
The dishwasher fills the tank automatically. At the end of
this phase, when the tank is full,
display and program lights L5, L6, L7 are lit.
Load the dishes and close the door.
Select the programme required by pressing one of the
three buttons; the LED of the selected program flashes
and the other two go out. Hold down for about 2" to
confirm. The LED starts to flash and the washing cycle
starts. While washing is in progress the display shows
the water temperature in the tank. During rinsing, it
shows the boiler temperature.
At the end of the program the program LED comes on
and "End" flashes on the display.
Unload the dishes
15
P
appears on the