Set-Up; Dishwasher Parameter Modification Procedure - Smeg CWC620D Manual

Whenever the type of detergent or rinse aid is changed, it is ABSOLUTELY ESSENTIAL to flush out
the peristaltic pumps by placing the external intake pipes in water for a few cycles.
Always use only products specifically recommended for use in a dishwasher.
Failure to comply with this recommendation leads to forfeiture of the warranty entitlement on
the appliance's water system.
The internal pipes of the detergent and rinse aid pumps should be replaced by the After‐Sales
Service every 12 months or 15,000 wash cycles and operation of the diaphragm rinse aid pump
should be checked.
Set‐up
During first start‐up, the functions/parameters listed below must be set or adjusted:
6.1 Dishwasher parameter modification procedure:
Only accessible after filling is complete or with the hood open.
Access "programming mode" by pressing the
a few seconds with the appliance on with the hood open
and the tank empty (after the filling and heating phases).
The display shows UnLo1:58; when the beep sounds,
release the button and press it again at once. Keep
pressing the button again to scroll through all the
modifiable parameters in the following order:
Rinsing temperature (boiler temperature)

6 SET-UP

‐ CW 620/630
IMPORTANT:
button for
13