Cleaning the filter during the day
In case of particularly heavy‐duty working conditions, the filter should be cleaned every 30‐40 cycles,
keeping the machine in operating conditions; to do this, carry out the "partial tank pump‐out" routine
(program "P0").
Remove the filters (simply lift them out as shown here), taking care
that no large residues fall into the sump underneath. Clean them to
remove residues and rinse with plenty of water, then put them
correctly back in place; do not use sharp or pointed tools.
Clean away any limescale deposits to prevent excessive build‐ups;
‐
If possible, leave the hood ajar when not in use;
‐
Clean surfaces thoroughly and often with a damp cloth; use
neutral, non‐abrasive detergents which do not use chlorine
compounds, which corrode and damage stainless steel.
Do not use the products mentioned above even when cleaning the floor underneath or in the vicinity of
the dishwasher,
to ensure that fumes or drops cannot damage the steel surfaces.
IMPORTANT:The dishwasher automatically performs program "P0" at the start of the day if water has
been left in the tank and has dropped below the temperature of 40°C
‐ CW 620/630
Press the
button, and hold it down, until "P0" and
the duration of 1' appear on the display.
Confirm by pressing
At the end of the pump‐out the word "End" flashes on
the display. The display returns to showing "P1". Clean
the filter; the dishwasher automatically fills the tank
when the hood is closed.
31
; light L2 turns orange.