INADEQUATE RINSING
DISHES NOT PROPERLY
DRIED
STAINS ON GLASSES AND
CUTLERY
WATER IN TANK AFTER
PUMP‐OUT
‐ CW 620/630
Too little or unsuitable
detergent or rinse aid
No or not enough detergent or
rinse aid being supplied:
detergent or rinse aid not being
taken from the relative
container.
Plates/glasses badly arranged
Low washing temperature
Inappropriate cycle set
Spray arm nozzles fouled
Limescale in boiler
Rinse aid unsuitable or not
being delivered correctly.
Rinsing temperature too low
Rinse aid unsuitable or not
being delivered correctly.
Water hardness above 12°f or
large amounts of dissolved salts
Drain hose incorrectly
positioned or partially
obstructed.
Drain hose incorrectly
positioned or partially
obstructed.
33
day"
Check type and quantity of
detergent.
Pipe inside detergent and/or rinse
aid peristaltic pump worn or broke,
have it replaced by the After‐Sales
Service.
Arrange plates/glasses correctly.
Check temperature shown on the
display, call the after‐sales service if
less than 50
Increase washing duration,
especially if dishes are very dirty or
dirt has dried on.
‐ Check that nozzles are clean, and
ensure that the softener is working
properly (if installed).
‐ Check that the filter of the hose
inserted in the rinse aid tank is not
fouled.
Check container of rinse aid and
whether it is suitable for the type
of mains water. Check boiler
temperature setting
If the problem persists, contact the
after‐sales service.
Check container of rinse aid and
whether it is suitable for the type
of mains water. Restore T Stop ON
and/or connect the appliance to a
hot water supply.
If the problem persists, contact the
after‐sales service.
Check that the dishwasher hose
and drain are unobstructed and the
drain is not too high up; see
connection diagram.
Check that the dishwasher hose
and drain are unobstructed and the
drain is not too high up; see
connection diagram.