Operating Your Appliance; Control Panel - Summit SDHR1534 User Manual

OPERATING YOUR APPLIANCE

It is recommended you install the appliance in a place where the ambient temperature is between 44ºF
and 90ºF (7ºC to 32ºC). If the ambient temperature is above or below the recommended temperatures,
the performance of the unit may be affected. For example, placing your unit in extremely cold or hot
conditions may cause interior temperatures to fluctuate. The optimal temperature range may not be
reached.
Control Panel for Refrigerators
ON/OFF Power
To turn the appliance OFF, press the
To turn the appliance ON, press the
NOTE:
Pressing the POWER key once can switch off the audible alarm when the alarm is on.
Light
To turn the interior light on/off, press and hold the
will light up or go out to confirm the selection. The interior light indicator is the dot at the bottom
right of the display.
The interior light makes it easy to view your items. Pressing and holding the LIGHT symbol for 5
seconds toggles between 2 modes of operation for the internal lights: functional (default) mode
and showcase mode. If you are in functional (default) mode, the lights will turn on only when the
door is open. If you are in showcase mode, the lights will be on whether or not the door is open.
UP
Used to increase (warm) the set temperature by 1ºF/1°C.
DOWN
Used to decrease (cool) the set temperature by 1ºF/1°C.

Setting the Temperature Control
You can set the temperature by touching the UP and DOWN symbols. When you push either
of the two buttons for the first time, the LED readout will show the original temperature set

previously. (The temperature preset at the factory is 38°F or 3°C.)
The temperature you are setting will increase by one degree each time you touch the UP

symbol and will decrease by one degree each time you touch the DOWN symbol.

The range of the temperature control is from 36°F to 43°F.
To view the set temperature at any time, touch the UP or DOWN symbol. The set temperature
will flash in the display window for 5 seconds. After 5 seconds, the temperature inside the unit
will reappear in the display window.
symbol and hold for 5 seconds.
symbol and hold for 1 second.
key for 5 seconds. The interior light indicator
17