Table of Contents
Advertisement
Quick Links
FROST-FREE DRAWER REFRIGERATORS
Model Nos. FF1DSS / FF1DSS24 / FF12DROS / HDR13SS
BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS.
Write Serial Number (on lower left outside of
drawer) here:
_______________________
Serial No.:
SDR24 / SDR241OS / DR124SS
SDR30 / SDR301OS / DR130SS
SDR36 / SDR361OS / DR136SS
User Manual
Felix Storch, Inc.
An ISO 9001:2015 registered company
770 Garrison Avenue
Bronx, NY 10474
www.summitappliance.com
Advertisement
Table of Contents
Related Manuals for Summit FF1DSS
Summary of Contents for Summit FF1DSS
- Page 1 FROST-FREE DRAWER REFRIGERATORS Model Nos. FF1DSS / FF1DSS24 / FF12DROS / HDR13SS SDR24 / SDR241OS / DR124SS SDR30 / SDR301OS / DR130SS SDR36 / SDR361OS / DR136SS User Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS.
-
Page 2: Table Of Contents
TABLE OF CONTENTS Appliance Safety Important Safeguards Location of Parts Installation Instructions Before Using your Appliance Installation of your Appliance Electrical Connection Extension Cord Installing the Stainless Steel Handle Installing the Anti-tip Brackets Full Overlay Panel Installation Instructions Operating your Appliance 10-12 Control Panel 10-11... -
Page 3: Appliance Safety
APPLIANCE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. The symbol alerts you to potential hazards that can kill or injure you and others. - Page 4 In the event of any damage: – Avoid open flames and anything that creates a spark, – Disconnect from the power source, – Air the room in which the appliance is located for several minutes, and – Contact the Service Department for advice. The more coolant there is in an appliance, the larger the room in which it should be installed.
-
Page 5: Location Of Parts
LOCATION OF PARTS Control Panel Handle Drawer Adjustable Legs... -
Page 6: Installation Instructions
INSTALLATION INSTRUCTIONS Before Using your Appliance Remove the exterior and interior packing. Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. -
Page 7: Extension Cord
This appliance requires a standard 115/120 Volt AC ~ 60Hz three-prong grounded electrical outlet. Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet. -
Page 8: Installing The Anti-Tip Brackets
Installing the Anti-Tip Brackets Included with this unit is a pair of anti-tip brackets to help prevent the unit from moving inside the countertop when opening the drawer. Place the provided brackets in front of the unit’s ventilation grille as shown the figure. Then, secure the brackets to both walls and the unit using the included screws. - Page 9 Ensuring an even track engagement on both sides, gently push the drawer into the cabinet until it stops. * Suggested Panel Sizes: SDR24: 23.4” W x 15.6” H SDR30: 29.5” W x 15.6” H SDR36: 35.4” W x 15.6” H FF1DSS models: 21.4” W x 15.6” H...
-
Page 10: Operating Your Appliance
OPERATING YOUR APPLIANCE It is recommended you install the appliance in a place where the ambient temperature is between 44º and 100ºF (7º to 38ºC). If the ambient temperature is above or below the recommended temperatures, the performance of the unit may be affected. For example, placing your unit in extremely cold or hot conditions may cause interior temperatures to fluctuate. -
Page 11: Interior Light
and will decrease by one degree each time you touch the DOWN symbol. The range of set temperatures is from 36°F to 43°F. To view the set temperature at any time, touch the UP or DOWN symbol. The set temperature will temporarily flash in the display window for 5 seconds. -
Page 12: Temperature Alarm/Door Alarm
Temperature Alarm / Door Alarm An audible alarm sounds if the storage temperature is not cold enough. The temperature display flashes at the same time. The cause of the temperature being too high may be: – Warm fresh food was placed inside Too much warm ambient air flowed in when rearranging and removing food –... -
Page 13: Care And Maintenance
CARE AND MAINTENANCE Cleaning your Appliance Turn off the power, unplug the appliance, and remove all items, including racks and dividers. Wash the inside surfaces with a solution of warm water and baking soda (about 2 tablespoons of baking soda to a quart of water). Wash the racks and dividers with a mild detergent solution. -
Page 14: Troubleshooting
TROUBLESHOOTING You can solve many common problems easily, saving you the cost of a service call. Try the suggestions below to see if you can solve the problem before calling the servicer. Troubleshooting Guide PROBLEM POSSIBLE CAUSE REMEDY Appliance is not connected to a Connect the appliance. - Page 15 will not close feet. properly. The gaskets are dirty. Clean the drawer gaskets. The racks or bins are out of position. Check the racks and bins and refit them correctly. “E0” indicates a communication error Call for service. for 3 zone models. Display “E0”, “E1”...
-
Page 16: Limited Warranty
LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, the warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company.