Table of Contents
Advertisement
About this task
The following image indicates the location of the power button with fingerprint reader and provides a visual representation of
the installation procedure.
Steps
1. Align and place the power button, along with the fingerprint-reader cable, on the slot of the palm-rest and keyboard
assembly.
2. Align the screw holes on the power button with the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M1.6x2) that secure power button to the palm-rest and keyboard assembly.
Next steps
1. Install the
I/O
board.
2. Install the
display
assembly.
3. Install the fan.
4. Install the
base
cover.
5. Follow the procedure in
6. Exit
Service
Mode.
System board
Removing the system board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
memory
modules.
5. Remove the
wireless
card.
6. Remove the
M.2 2230 solid-state drive
7. Remove the
heat
sink.
8. Remove the fan.
About this task
The following image indicates the connectors on your system board.
52
Removing and installing components
After working inside your
Before working inside your
or
M.2 2280 solid-state
computer.
computer.
drive, whichever applicable.
Advertisement
Table of Contents
