Removing The System-Board Shield; Replacing The System-Board Shield - Dell XPS L701X Service Manual

Back to Contents Page
System-Board Shield
Dell™ Inspiron™ One 2305/2310 Service Manual
Removing the System-Board Shield
Replacing the System-Board Shield
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
Removing the System-Board Shield
1. Follow the instructions in Before You
2. Remove the back cover (see
3. Follow the instructions from
4. Remove the four screws that secure the system-board shield to the chassis.
5. Carefully lift the system-board shield and turn it over to the left of the computer.
1 system-board shield
6. Disconnect the antenna-in connector cable from the connector on the TV tuner card.
7. Disconnect the infrared (IR) blaster connector cable from the connector (CIR Emitter) on the system board.
8. Release the antenna-in connector cable and IR blaster connector cable from the routing guides on the system-board shield.
9. Follow the instructions from
10. Follow the instructions from
Replacing the System-Board Shield
1. Follow the instructions in Before You
2. Follow the instructions from
3. Follow the instructions from
Begin.
Removing the Back Cover).
step 2 to step 5 in Removing the Front
2 screws (4)
step 5 to step 7 in Removing the Antenna-In
step 5 to step 7 in Removing the Infrared (IR) Blaster
Begin.
step 2 to step 5 in Replacing the Infrared (IR) Blaster
step 2 to step 3 in Replacing the Antenna-In
Stand.
Connector.
Connector.
Connector.
Connector.