Choosing The Program; Supplementary Functions - Smeg CW500 Manual

PROGRAM
Glasses
P1
Glasses, cups and plates with light dirt
P2
Very dirty dishes and cutlery
P3
Depending on the duration set.
P4
(*)
The cycle duration stated above refers to three-phase appliances supplied with hot water at 50°C.
If the appliance is supplied with cold water, the cycle duration might increase depending on the intake
water temperature, since the dishwasher is fitted with the HTR system, which requires set temperature and
pressure for rinsing.
Indicator lights as follows:
To select a supplementary function, when the program required is shown on the display (P1, P2, P3 or P4)
press the button. Only one supplementary function can be selected for each program.
10.1 Selecting the "glassware" function (available in P1-P2)
Reduces the program's rinsing temperature and duration
10.2 Selecting the "extra rinse" function (available in P1-P2-P3-P4)
Extends the duration of the rinse

9 CHOOSING THE PROGRAM

TYPE OF DIRT

10 SUPPLEMENTARY FUNCTIONS

off; green; orange;
Short, about 1' 30"
1' with glassware function active.
Average, about 2' 30"
2' with glassware function active.
Long, about 4'
5'30" with sani function active.
As required from 5 to 20'.
flashing.
Select the program required
(7.4 OPERATION)
Hold down to select the glassware function then
to confirm the program start.
Select the program required
(7.4 OPERATION)
Hold down to select the extra rinse function then
to confirm the program start.
17
DURATION (*)