Program Change - Smeg CW500 Manual

When the door is closed again, the last program is repeated.

8.4 Program change

N.B.:
During heating of the water in the boiler, the tank heating element
may appear on the display.
Filter presence sensor (on some models only)
The filter is fitted with a sensor which checks that it is properly fitted; if it is not in the correct position, the word
"FiLter" appears on the display.
Cycle in progress, the time left until the end of the cycle
is displayed. If the door is opened "CLOSE" flashes and
the program stops; when it is closed again the program
restarts from the beginning.
At the end of the program "End" flashes
Unload the dishes
With the door closed, to change to a fresh program
instead of repeating the last one, press the
The programs available are displayed (light L2 changes
from orange to green).
If a program has already started, hold
interrupt it.
change the program by pressing
Confirm the program start by pressing
down for 1 second (light L2 changes back to orange).
and boiler heating element
16
button.
down to
.
and holding it
symbols