NEC MultiSync XG750A Setup Manual page 49

ADJUSTMENT
3) Use the CURSOR buttons to align the pattern.
When selecting "CENTER":
• Pressing the CURSOR
Pressing the CURSOR
To switch to the "EDGE" screen, press and hold the CTL, then
press CUSOR or
When selecting "EDGE":
• Pressing the CURSOR
• Pressing the CURSOR
To switch another screen, press and hold the CTL, then press
CUSOR or button.
7 Repeat steps 3 to 6 for the other CRTs if necessary.
• Pressing the END button will bring you to the "CONVER-
GENCE" menu.
8 To exit, press END.
• Whenever the END button is pressed, the menus will sequence
in this order:
"CONVERGENCE" menu → "ADJUST" menu → Source
screen
• If the "RETURN USER MODE?" menu appears, use the
CURSOR or button to select either "YES" or "NO" and
then press ENTER. This will exit the ADJUST mode.
Items to select
• YES ......... When you try to enter the ADJUST mode again,
you will need to re-enter your passcode.
• NO ........... When you try to enter the ADJUST mode again,
you will not need to re-enter your passcode.
NOTE: Adjusting the dynamic convergence may cause the static
convergence settings to change. If this happens, adjust the
static convergence again.
or button increases the level.
or button decreases the level.
button.
or button increases the level.
or button decreases the level.
CONVERGENCE
- LINE DIST. CENTER -
CRT –R–
C ONV E RGE N CE
- LIN E D IS T. E DGE -
CRT –R–
SCREEN –TOP–
C O N V E R G E N C E
- K E Y - S T O N E -
C R T - R -
S C R E E N - T O P -
50
+ 1 0 %
R ETURN US ER MO DE ?
Y E S N O
0%
0%