Battery Installation And Replacement; Remote Control Cautions; Handling Remote Control And Batteries - NEC MultiSync XG750A Setup Manual

Battery installation and replacement

User remote control (RC-6320)
1
Press down on the battery compartment cover and slide
the cover in the direction of the arrow.
2
Install the two new batteries, making sure that their
polarity matches the , . diagrams inside the battery
compartment. Incorrect polarity could damage the unit.
3
Close the battery compartment cover.
NOTE: The remote control is powered by two alkaline 1.5V
AA batteries.

Remote control cautions

Use the remote control within a distance of about 7m (23 ft.) and at 30 degrees angle left and right.

Handling remote control and batteries

• Do not drop or mishandle the remote.
• Do not get the remote wet. If the remote gets wet, wipe it dry immediately.
• Avoid heat and humidity.
• When not using the remote for a long period, remove the batteries.
• Do not use new and old batteries together, or use different types together.
• Do not take apart the batteries, heat them, or throw them into a fire.
• Avoid using the full function remote control as wireless with the backlight switch ON for an extended period of time. This can
cause short battery life.
Full function remote control (RC-6321)
1
Press down on the battery compartment cover and slide
the cover in the direction of the arrow.
2
Install the two new batteries, making sure that their
polarity matches the , . diagrams inside the battery
compartment. Incorrect polarity could damage the unit.
3
Close the battery compartment cover.
11
PART NAMES AND FUNCTIONS