Table of Contents
Advertisement
Message
*D-CONV COMMUNICATION ERROR*
*D-CONV CPU NOT READY*
*POINT DATA WRITE ERROR*
*SELECTED SCAN NUMBER IS NOT USED*
*SEQUENCER DATA ERROR*
*SEQUENCER ABNORMAL END*
*SEQUENCER END*
*CAN NOT SELECT*
*POINT LIMIT OVER*
*SEQUENCER MANUAL END*
*THIS COLOR IS NOT APPLICABLE*
*NEW SIGNAL!!*
*WARNING DIFFERENT PASSCODE!!*
*WARNING PASSCODE!!*
*WARNING ADDRESS!!*
*FOR SERVICE PERSONNEL ONLY*
*DELETING*
*ENTRY LIST IS FULL !*
*THE PROJECTOR WILL TURN OFF SOON*
*Please contact service personnel if there are frequent occurrences.
Conditions
D-CONV PWB communication error
D-CONV PWB communication error
POINT DATA write error
Selection of an unregistered line on the
INPUT LIST
POWER OFF or an INPUT command
was not set in the SEQUENCER user
program
An error occurred while the SE-
QUENCER user program was running,
and the program was forced to stop.
AUTO SEQUENCER finished
Attempt to select an item that cannot
be selected
POINT adjustment data are at a
maximum
There was a manual completion when
the AUTO SEQUENCER was running.
The selected tube was not on during
the gain adjustment.
An unregistered signal has been input.
Passcode input mistake
Invalid passcode input
Invalid PJ address input
Function for service personnel.
Signal is being deleting from INPUT
LIST.
There is no space for signals No. 51
and later in Input List when "NEW" is
selected from "STORE?" menu.
The projector will turn off in three
minutes when ON/OFF or SLEEP
TIMER is set to ON.
131
MASSAGE LIST
Countermeasures
*
*
*
Select a registered line.
Reset the SEQUENCER.
Reset the SEQUENCER.
-
There is an unselectable item due to
the input signal or the connection
condition of the peripheral equipment.
Reduce the correction data, combine
other adjustments, and adjust.
-
Switch on the adjustment tube.
Signal registration
Input the registered passcode.
0000 and 9999 cannot be used
Input 01 to 64
Not adjustable by the end user.
-
Make an entry in SIGNAL ENTRY or
delete signals for No. 51 or later from
Input List to create space.
Disable or change the timer.
Advertisement
Table of Contents
