Table of Contents
Advertisement
Storing Projector Settings (Automatic Save Feature)
You have two options to store projector settings in the memory:
automatically and manually.
• The Automatic Save Feature mode has been set to DISABLE by
factory. For information on setting, see "Automatic Save Feature"
in the Set-Up manual included only with the XG-1351/XG-1101/
XG-751 models, and if you own XG-1351G/XG-1101G/XG-751G,
contact your dealer.
When the Automatic Save Feature mode is set to "ENABLE",
projector settings will be stored in the projector's memory
automatically.
Settings are stored automatically when any one of the following
procedures is performed:
• The END button is pressed several times to return the adjust-
ment screen to the source screen.
• One input is switched to another.
• The projector is turned off.
• After every 10 minutes of elapsed time.
When the Automatic Save Feature mode is set to "DISABLE",
projector settings can be stored in the projector's memory
manually.
When you try to return the source screen by pressing END
several times, the "STORE ?" menu is displayed.
To manually save settings, proceed as follows:
1. Use the END button to display the "STORE" menu from the
current adjustment screen or menu.
2. Use the CURSOR
"NEW", or "CANCEL" and press ENTER.
Items to select
• CURRENT ------ Overwrites the currently projected signal and
saves the settings. NOTE: An unregistered signal
cannot be stored under the ''CURRENT''
settings.
• NEW ------------ Starting at memory location No.51, this function
saves an unregistered signal as a new signal in
memory.
• CANCEL -------- Does not save settings.
or
button to highlight "CURRENT",
CURRENT
15
BEFORE SET-UP
STORE ?
NEW
CANCEL
Advertisement
Table of Contents
