Functioning Of The Charging Base; Battery Charging - Stiga G 300 Instruction Manual

5.4.

FUNCTIONING OF THE CHARGING BASE

The charging base is equipped with an indicator light (N) that lights up in the following manner:
• Warning light off: the charging base is powered off or the robot is on the base;
• Fixed warning light: the perimeter cable is correctly connected to the charging base, and the
perimeter signal is correctly transmitted;
• Indicator light flashing slowly: the perimeter cable is not connected or is interrupted (the perimeter
cable integrity check is not performed continuously, but only when the robot leaves the charging
base or the base is powered);
• Warning light flashing quickly: the perimeter cable is too short (see Par. 4.5.4) or there is a fault in
the charging base.
• Indicator light flashing rapidly twice or three times: the charging base has detected a short circuit
on the charging contacts. (See Chap. 7).
5.5.

BATTERY CHARGING

The "BATTERY CHARGING" procedure allows to recharge the robot lawn mower manually.
Requirements and obligations:
• charging base connected to the mains.
Procedure:
1. Position the robot lawn mower on the charging base (R).
2. Slide the robot lawn mower onto the charging base, until the charging connector (S) is engaged.
3. Press the "STOP" button (A) to open the cover (B) and access the control panel (C).
4. Turn the robot lawn mower on with the "ON/OFF" button (E).
5. A few seconds later, the "BATTERY" icon (O) flashes blue to indicate that the robot lawn mower is
charging.
6. Close the cover (B).
7. Leave the robot lawn mower to charge for at least the time shown in Par. 4.6.
NOTE: Charging the battery before winter storage should be carried out as shown in Par. 6.4.
A
46
5. OPERATION
R
C B S
N
O
E
EN