Stiga G 300 Instruction Manual page 31

Procedure:
1. Place the perimeter cable (A) starting from the charging base installation area.
2. Place the cable along the entire path, fixing it with the suitable pegs (B) spaced approximately
100 cm apart, and observing the installation requirements (See Par. 4.3 and Par. 4.4).
3. Leave 2 m of cable or more to subsequently cut it to size in the final phase of connection.
NOTE: In non-straight sections, make sure that the cable (A) does not get tangled. Position the
cable in such a way as to form a regular curve with a radius of about 20 cm
NOTE: The perimeter cable used for installation must be at least 40 m. long. If the cable is
shorter, it will be necessary to install the resistor for small perimeters. (See Par. 4.5.4. and
Chap. 9 "Accessories").
WARNING:
Make sure that the cable is in contact with the ground along its path to prevent
the robot lawn mower from damaging it.
POSITIONING UNDERGROUND
(CARRIED OUT ONLY BY AUTHORIZED RETAILER)
Turning to a STIGA retailer, the perimeter cable can also be installed using a specific wire-laying machine,
without using pegs.
EN
A
B
4. INSTALLATION
27