Stiga G 300 Instruction Manual page 47

Procedure:
1. Press the "STOP" button (A) to open the cover (B) and access the control console (C).
2. Press the "MODE SELECT" button (F) until the icons of the functions you wish to activate flash. The
icons relating to the selected functions flash.
3. Press the "CONFIRM" push button (G). The icons of the selected functions light up steadily to confirm
the action.
4. Close the cover (B).
5. The robot lawn mower will start working according to the set mode.
NOTE: If after pressing the "CONFIRM" button (G), the "SELECT MODE" button (F) is pressed,
the icons for the selected functions will start flashing again, requesting to confirm the newly
selected function. Press the "CONFIRM" button (G). The icons return to a steady light.
NOTE: if the cover (B) is opened, either during work or with the robot in the base, the icons
relating to the selected functions will flash,to indicate that it is necessary to confirm the operation
before closing the cover again. If the cover is closed without pressing the "CONFIRM" button
(G), the robot will not perform any task until a new command is given by the user.
NOTE: If the robot battery is low, the battery icon flashes red to indicate that the selected action
cannot be performed.
NOTE: The robot lawn mower starts only after closing the cover (B).
NOTE: The robot lawn mower goes to the charging base with the cutting device switched off.
A
C
NOTE: The robot lawn mower can be used in "SINGLE WORK CYCLE" mode even without
programming the working hours via the App. This mode may not guarantee adequate coverage
of the garden, both in terms of time required and in terms of uniformity of the cutting result,
especially if the garden has an irregular shape. To achieve the maximum efficiency of the robot
lawn mower, it is recommended to carry out programming (See Par. 4.7).
EN
D B
I
L
G
E F
5. OPERATION
43