Stiga G 300 Instruction Manual page 34

4. Install the charging base aligned with the perimeter cable (D2) so that the robot will be able to
access it by navigating the perimeter cable clockwise.
5. Insert the two ends of the cable into the appropriate slots (E2).
6. Cut the ends of the cables to the exact length.
7. Apply the self-drilling connectors on the cable (F), (G), (H).
8. Connect the connectors to the terminals (I).
9. Secure the charging base (L) to the ground with the fixing screws (M).
10. Reposition the cover (C).
11. Connect the power supply connector to the charging base and then insert the power supply plug into
the electrical outlet.
12. When the robot lawn mower is not in the charging base, make sure that the indicator light on the
charging base (N) is lit with a fixed light (see Par. 5.4).
30
4. INSTALLATION
D2
F
I
E2 E2
G
H
EN