Table Of Contents - MSA fieldserver ProtoNode FPC-N54 Operating Manual

Contents
1 Introduction
1.1 ProtoNode Gateway
2 Setup for ProtoNode
2.1 Record Identification Data
2.2 Point Count Capacity and Registers per Device
2.3 Configuring Device Communications
2.3.1 Confirm the Device and ProtoNode COM Settings Match
2.3.2 Set Node-ID for Any Device Attached to the ProtoNode
2.4 Device Connections to ProtoNode
2.5 Wiring Field Port to RS-485 Serial Network
2.6 Bias Resistors
2.7 Termination Resistor
3 Power up the Gateway
4 Connect the PC to the Gateway
4.1 Connecting to the Gateway via Ethernet
4.1.1 Changing the Subnet of the Connected PC
5 Setup Web Server Security
5.1 Navigate to the Login Page
5.2 Login to the FieldServer
5.3 Select the Security Mode
5.3.1 HTTPS with Own Trusted TLS Certificate
5.3.2 HTTPS with Default Untrusted Self-Signed TLS Certificate or HTTP with Built-in Payload Encryption
6 Configure the ProtoNode
6.1 Select Field Protocol and Set Configuration Parameters
6.2 Setting Active Profiles
6.3 Verify Device Communications
6.4 Ethernet Network: Setting IP Address for the Field Network
6.5 BACnet: Setting Node_Offset to Assign Specific Device Instances
6.6 How to Start the Installation Over: Clearing Profiles
7 Troubleshooting
7.1 Lost or Incorrect IP Address
7.2 Viewing Diagnostic Information
7.3 Checking Wiring and Settings
7.4 LED Functions
7.5 Factory Reset Instructions
7.6 Internet Browser Software Support
7.7 Taking a FieldServer Diagnostic Capture
8 Additional Information
8.1 Update Firmware
8.2 BACnet: Setting Network_Number for More Than One ProtoNode on the Subnet
8.3 Mounting
8.4 Certification
8.5 Physical Dimensions
8.6 Change Web Server Security Settings After Initial Setup
8.6.1 Change Security Mode
8.6.2 Edit the Certificate Loaded onto the FieldServer
8.7 Change User Management Settings
4 Lochinvar ProtoNode FPC-N54 Guide
6
6
7
7
7
7
7
7
8
8
9
10
11
12
12
12
13
13
13
15
16
16
17
17
18
19
20
21
21
22
22
23
24
25
25
25
26
27
27
27
28
28
29
30
30
31
32
US