Table of Contents
Advertisement
English
7.6.2
After a Period of Inactivity
Empty the water tank, wash and rinse it and fill it with
fresh water (see section "Filling the Water Tank").
Place a large container under the coffee dispensing
spout.
Open and close the capsule loading tray and press the
"Coffee" button - without inserting the capsule - to
start brewing. The machine starts brewing coffee from
the dispensing spout. Wait until brewing has been
completed and empty the container. Repeat the
brewing cycles 3 times, opening and closing the
capsule loading tray each time. Place a container under
the hot water dispensing spout.
Press the "Hot Water" button. The machine starts
dispensing hot water. Then it stops automatically.
Continue dispensing water until the no water icon is
displayed.
30
When the hot water dispensing procedure has been
completed, empty the container. Fill the water tank
again up to the MAX level. The machine is now ready
for use.
7.7
Washing the Parts coming
into Contact with Food
Rinse all the parts coming into contact with food.
• Thoroughly wash your hands.
• Prepare a chlorine-based, antibacterial disinfecting
solution (the products can be purchased at the
chemist's) following the concentrations indicated on
the product.
• Remove all the covers and all the containers from the
appliance.
• Immerse all these parts in the previously prepared
solution.
7.8
Using the Appliance
Before using the machine,
read this manual carefully
and make sure users are
familiar with the machine.
After the machine has not
been used for a certain
time, it is recommended
to read section "First Use -
Use after a Long Period of
Inactivity"
using the module again.
The beverage selection modes are indicated in chapter
"Operation and Use".
again,
before
Advertisement
Table of Contents
