Coffee Grind Adjustment; First Start-Up Of The Vending Machine; Water Circuit Filling; Washing The Parts Coming Into Contact With Food - Saeco Phedra Evo D.A. 5P2015 Operation And Maintenance

English
7.7

Coffee Grind Adjustment

Turn the ring until the required results are obtained.
After any calibration three selections are necessary before
the new setting becomes effective.
7.8 First start-up of the vending
machine
Supply the vending machine (following the instructions
given previously) and plug it into the power supply (see
section "Power Grid Connection").
At this point the message "PHEDRA EVO" will appear on
the display and the self-diagnosis phase is activated to
check the correct positioning of the machine devices.
Any faults detected during the self-configuration cycle are
stored so that the vending machine can display them at the
end of the self diagnostic phase.
Carry out the grinder adjustment as indicated in the
instructions at section "Coffee Grinder Adjustment" after
refilling the water circuit.
7.9

Water circuit filling

At first VM start-up, the boiler is filled automatically.
7.9.1 Filling the boiler manually
After switching the vending machine on it is possible to fill
the boiler by activating the following procedure:
Procedure A
• press the P2 key to enter the maintenance menu;
• Enter the Maintenance/Washes menu and start the
automatic washing cycle;
42
Procedure B
• press the P2 key to enter the maintenance menu;
• Enter the Maintenance/ Boiler Refill menu and start the
automatic refill cycle;
The rinsing operation must
be repeated until water
flows out of the brewing
nozzles regularly.
7.10 Washing the Parts coming
into Contact with Food
Clean all the parts of the VM which are in contact with
foodstuffs.
• Thoroughly wash your hands.
• Prepare a chlorine-based, antibacterial disinfecting solution
(the products can be purchased at the chemist's) following
the concentrations indicated on the product.
• Remove all the product containers from the vending machine.
• Remove the container lids and product chutes. Immerse
all these parts in the previously prepared solution.
7.11

Use of the vending machine

The beverage selection modes are indicated in chapter
"Operation and Use".